Marmitek AW12 Manual De Instrucciones página 6

• Pull an additional Neutral wire if it is missing.
• Connect the live and neutral to the terminal wires of the AW12 as described in figure A.
• Connect the wire from the In-Wall module to the switch.
• Connect the live to the switch.
• Replace the wall switch.
• Switch on mains fuse and master switch.
Programming.
Programming the address and the optional
functions All Lights On/All Lights Off/All Units
Off:
The factory setting for the AW12 is to
address A1 and no response to the optional
functions All Lights On/All Lights Off/All Units
Off.
Unlike most Marmitek X-10 Modules the
AW12 does not have code wheels.
To change the address and the settings for
the All Lights On/All Lights Off/All Units Off
functions, the module needs to be set to the
program mode.
Activating the program mode can be done in
2 ways:
1. By transmitting On / Off commands of
the set address in quick succession (e.g.
if the address is B2: B2 ON, B2 OFF, B2
ON, etc.)
After the relay has changed state 5
times, with no more than 1.5 seconds
between changes, the relay will no
longer respond, which means the module is set to the program mode.
2. By quickly pressing/switching the (momentary) switch connected to the module. After the
relay has changed state 5 times, with no more than 1.5 seconds between changes, the
relay will no longer respond, which means the module is set to the program mode.
Once in Program Mode the new address can be set by sending an "Address" or "Address
On" (e.g. B2 ON) or "Address Off" command for the new address code twice (using any
Marmitek X-10 controller). If you want to change the code again, just send the revised code
twice as before.
To set the unit to respond to "All Lights On" and/or "All Lights Off" and/or "All Units Off"
just send these commands twice for the new address code (using any X-10 controller).
Please note: The "All Lights On/All Lights Off /All Units Off " options can be disabled by
setting a new address or by returning to the Default Setting.
6
A.
Standard Switch or momentary switch
Neutral
Lamp
Live
Switch or key
B.
2-Way Switching
Neutral
Lamp
Live
Switch
N
N
L
SL
N
N
L
SL
Switch
© MARMITEK