Technical Data - Marmitek AW12 Manual De Instrucciones

be disturbed when more than one TM13 is transmitting. TM13's will wait for a quite power
line before transmitting their data. To prevent your Marmitek X-10 System to become slow or
to prevent dimming from becoming less smooth, make sure that the TM13 units are placed
as far away from each other as possible.
My AW12 doesn't work.
• Is the switch for the light or appliance you are trying to control turned on?
• Does the light or appliance work if you connect it directly to the mains?
• Is the module connected to a surge protector? A surge protector might block signals
from your interface or controller.
• Is the Housecode set correctly?
Do you still have questions? Please check out www.marmitek.com for more
information.

Technical Data

Supply voltage:
Supply current :
Switching power:
Minimum load:
Signal sensitivity:
Input impedance:
Connections:
Ambient temperature:
Dimensions:
Environmental Information for Customers in the European Union
European Directive 2002/96/EC requires that the equipment bearing this symbol on the product and/or its
packaging must not be disposed of with unsorted municipal waste. The symbol indicates that this product
should be disposed of separately from regular household waste streams. It is your responsibility to dispose
of this and other electric and electronic equipment via designated collection facilities appointed by the
government or local authorities. Correct disposal and recycling will help prevent potential negative
consequences to the environment and human health. For more detailed information about the disposal of your old
equipment, please contact your local authorities, waste disposal service, or the shop where you purchased the
product.
8
230V - 50 Hz
< 20 mA capacitive
3600 W/230V for resistive (ohm) load
600 W/230V for inductive/capacitive load
2000 W/230V for light bulbs and low voltage halogen lights with
transformer.
3W
15 mVpp min 50 mVpp max at 120 kHz
> 180 Ohm (L - N) at 120 kHz
Wire for a standard pressure switch or momentary switch and
connecting clamps for phase, neutral and switched phase.
- 10° C to + 40° C (operation) - 20° C to + 70° C (storage)
46x46x17mm
© MARMITEK