Load; Accessories And Modifications; Checks Before Driving; Charge Level - Seat MÓ Manual De Instrucciones

Load

This eScooter is designed to be driven safely
as long as the maximum load capacity and
proper distribution are respected. Failure to
do so may compromise the stability, braking
power and manoeuvrability of the eScooter.
The maximum mass of the eScooter cannot
be more than 320 kg, including the vehicle
itself with its battery and accessories, the
driver and the passenger, when applicable,
and any load. Weight must be distributed
evenly across the two axles.
Remember that the weight of any accesso-
ries that are installed will reduce the addition-
al load that the eScooter can carry.
¬ WARNING
•
Distribute the load evenly on the eScoot-
er and try to keep it as close to the centre
as possible.
•
Make sure the load is firmly tied down
and avoid carrying loose objects.
•
Always make sure tyres are properly
inflated and adjust the rear suspension
to suit the specific load in each case
page 10, Tyres. To safely adjust the rear
suspension, contact your official dealer or
a specialized workshop.
Safe driving
10

Accessories and modifications

We recommend using only SEAT accessories,
as they have been designed and tested to
ensure they work properly with this model of
eScooter.
If you use other accessories or modify them in
any way, you must make sure they are select-
ed and installed properly so that they:
•
Don't obstruct the turning radius of the
handlebar or interfere with the use of any of
the controls.
•
Don't reduce the side tilt angle or the
ground clearance.
•
Don't interfere with visibility or the beam of
any of the lights.
•
Do not tamper with the eScooter's electri-
cal or electronic components.
•
Comply with legal regulations.
›››

Checks before driving

Charge level

Check the charge level on the LCD screen.
If it is too low, we recommend charging the
battery before using your eScooter.

Lights and indicators

Replace parts if they do not work or have
been damaged, before driving.
When the speedometer lights don't work
properly, they start blinking more quickly to
indicate that there is a problem.

Stands

Make sure both the side stand and centre
stand are folded away.
The side stand has a sensor that prevents the
eScooter from being driven when it is de-
ployed, but the centre stand does not.

Tyres

Always make sure there are no punctures,
cracks or tears in the tyres, and that the tread
has not worn down. Never drive with worn or
defective tyres. See section ››› page 42,