Operating Procedures; Description Of Controls; Helpful Hints; Cleaning And Sanitizing Procedures - Delta AC 10 Manual De Instrucciones

AC 10

5 OPERATING PROCEDURES

1 - Clean and sanitize the unit according to
the instructions in this manual. See chapter
5 . 3 C L E A N I N G A N D S A N I T I Z I N G
PROCEDURES.
2 - Fill the bowl with product. Do not overfill.
The exact quantity of product (expressed
as liters and gallons) is shown by marks on
the bowl.
3 - Install the cover and check that they are
correctly placed over the bowls.
4 - Set the control switch as shown in chapter

5.1 DESCRIPTION OF CONTROLS.

5 - The dispenser must always run with the
cover installed to prevent a possible
contamination of the product.
6 - Always leave the dispenser on, as the
heating stops automatically when the
b e v e r a g e r e a c h e s t h e d i s p e n s i n g
tem per atur e. T h e mix ing de vic e will
continue to turn.
5. 1 DESCRIPTION OF CONTROLS
The dispenser is equipped with a power switch
whose functions are as follows:
0 position : power is turned OFF to all
functions.
I position : Pump ON
II position : Pump and heater ON
Beverage temperature adjustment: to reset
b e v e r a g e t e m p e r a t u r e p l e a s e t u r n t h e
thermostat knob.

5. 2 HELPFUL HINTS

IMPORTANT
If you decide to stop the unit when the
product is still in the bowl, set first the
switch to I position and wait until the
product reaches room temperature to
prevent it from sticking to the stainless
steel heating plate. Then switch the unit
off.
5. 3 CLEANING AND SANITIZING
PROCEDURES
Cleaning and sanitizing of the dispenser are
recommended to guarantee the conservation of
the best product taste and the highest unit
10
eff ic iency. This sect ion is a proc edural
g u i d e l i n e o n l y a n d i s s u b j e c t t o t h e
requirements of the local Health Authorities.
Prior to the disassembly and cleaning, the
machine must be emptied of product.

5. 3. 1 DISASSEMBLY

ATTENTION
Before any disassembly and/or cleaning
procedure make sure that the dispenser is
disconnected from its power source by
unplugging it or switching off the 2-pole wall
breaker.
1 - Empty the bowl and remove its cover.
2 - Uncouple the pump cover retainer and lift it
up and out.
3 - Remove the pump cover.
4 - Remove the empty bowl by lifting it up and
off gasket.
5 - Remove the bowl gasket.
6 - R e m o v e t h e p u m p i m p e l l er f r o m i t s
location.
7 - Push the dispensing handle and take the
pinch tube off from its seat.

5. 3. 2 CLEANING

ATTENTION
Before any disassembly and/or cleaning
procedure make sure that the dispenser is
disconnected from its power source by
unplugging it or switching off the 2-pole wall
breaker.
IMPORTANT
Do not attempt to wash any machine
components in a dishwasher.
1 - Prepare at least two gallons of a mild
cleaning solution of warm (45-60 °C 120-
140 °F) potable water and dishwashing
detergent. Do not use abrasive detergent.
Delta