Sanitizing; Assembly - Delta AC 10 Manual De Instrucciones

I m p o r t a n t : i f p r e s e n t , f o l l o w l a b e l
directions, as too strong a solution can
cause parts damage, while too mild a
solution will not provide adequate cleaning.
IMPORTANT
In order to prevent any damages to the
dispenser use only a detergent suitable
with plastics parts.
2 - Using a brush, suitable for the purpose,
thoroughly clean all disassembled parts in
the cleaning solution.
ATTENTION
When cleaning the machine, do not allow
excessive amounts of water around the
electrically operated components of the
unit. Electrical shock or damage to the
machine may result.
3 - Rinse all cleaned parts with cool clean
water.

5. 3. 3 SANITIZING

Sanitizing should be performed immediately
prior to starting the machine. Do not allow
the unit to sit for extended periods of time
after sanitization.
1 - Wash hands with a suitable antibacterial
soap.
2 - Prepare at least two gallons of a warm (45-
60 °C 120-140 °F) sanitizing solution (100
PPM available chlorine concentration or 1
spoon of sodium hypoclorite diluted with
two litres of water) according to your local
H e a l t h C o d e s a n d m a n u f a c t u r e r ' s
specifications.
3 - Place the parts in the sanitizing solution
following manifacture 's specifications
(about five minutes).
4 - Place the sanitized parts on a clean dry
surface to air dry.
5 - Wipe clean all exterior surfaces of the unit.
Do not use abrasive cleaner.

5. 3. 4 ASSEMBLY

1 - Push the dispensing handle and insert the
Delta
pinch tube into its vertical seat in the bowl
b o t t o m . L i g h t l y p u l l p i n c h t u b e e n d
downwards till it is well arranged.
2 - Fit the bowl gasket to the heating plate.
The largest brim of the gasket must face
against the plate.
3 - Place bowl on the unit pushing it down all
the way around the gasket. Wet the gasket
for ease of insertion.
4 - Replace the pump impeller and its cover
and hook the pump cover retainer.
AC 10
11