Technical Characteristics; Important; Introduction; Installation - Delta AC 10 Manual De Instrucciones

1 TECHNICAL CHARACTERISTICS

Transparent removable bowls
Capacity of each bowl, approx.
Dimensions:
width
depth
height
Net weight, approx.
Gross weight, approx.
Adjustable thermostats
Noise level lower than 70 dB (A)

IMPORTANT

Read electrical ratings written on the data
plate under the individual units. The
serial number of the unit is preceded by
the symbol #. Data plate specifications
will always supersede the information in
this manual.
Specifications are subject to change without
notice.

2 INTRODUCTION

Please read all sect ions of t his manual
thoroughly to familiarize yourself with all
aspects of the unit.
Like all mechanical products, this machine will
require cleaning and maintenance. Besides,
dispenser working can be compromised by
operator's mistakes during disassembly and
cleaning. It is strongly recommended that
personnel responsible for the equipment's daily
operations, disassembly, cleaning, sanitizing
and assembly, go through these procedures in
order to be properly trained and to make sure
that no misunderstandings exist.

3 INSTALLATION

1 - Remove the corrugate container and
packing materials and keep them for
possible future use.
Delta
2 - Inspect the uncrated unit for any possible
AC 10
n 1
3 - Install the unit on a counter top that will
l 10
4 - Ensure that the legs are screwed tightly
5 - Before plugging the unit in, check if the
cm 21
cm 28
cm 48
kg 5
kg 7
n 1
Failure to provide proper electrical ground
according to applicable electrical codes
could result in serious shock hazard.
6 - The unit doesn't come presanitized from

4 TO OPERATE SAFELY

1 - Do not operate the dispenser without
2 - Do not operate the dispenser unless it is
3 - Do not use extension cords to connect the
4 - Do not operate the dispenser unless all
5 - Do not put objects or fingers in panels
6 - Do not remove bowls, augers and mixers
damage. If damage is found, call the
delivering carrier immediately to file a
claim.
support the combined weight of dispenser
and product.
into the base of the machine.
voltage is the same as that indicated on
t h e d a t a p l a t e . P l u g t h e u n i t i n t o a
grounded, protected single phase electrical
s u p p l y a c c o r d i n g t o t h e a p p l i c a b l e
electrical codes and the specifications of
your machine. When the unit has no plug,
i n s t a l l a p r o p e r g r o u n d e d p l u g , i n
compliance with electrical codes in force in
your area, suitable to at least 10 Amp
250 Volt (220-230 Volts 50-60 Hz areas)
and 20 Amp 250 Volt (100-115 Volts 50-
60 Hz areas) applications. Should you
prefer to connect the unit directly to the
mains, connect the supply cord to a 2-pole
wall breaker, whose contact opening is at
least 3 mm. Do not use extension cords.
ATTENTION
the factory. Before serving products, the
dispenser must be disassembled, cleaned
and sanitized according to this handbook
i n s t r u c t i o n s
5 . 3 C L E A N I N G A N D S A N I T A Z I N G
PROCEDURES).
reading this operator's manual.
properly grounded.
dispenser.
panels are restrained with screws.
louvers and faucet outlet.
for cleaning or routine maintenance unless
the dispenser is disconnected from its
power source.
AC 10
( c h a p t e r
9