Key Automation 900CT-201 Manual De Instrucciones página 14

The great reliability of the system and the high concentration of the functions are managed by a
micro-controller so that the system can calculate all deceleration parameters based on the set wor-
The unit is equipped with basic programming that will provide you with the fundamental selected
based on the maximum opening and based on the type used where
Key Automation provides you with the table of times to be selected
for 90° as follows:
gramming functions can be adjusted: motor force, deceleration, etc.
and the point of the LCD on the left must be off. If it is on steady it means that the contact
is open.
and the point of the LCD on the left F1CL must be off. If it is on steady it means that the
contact is open
the corresponding safety is activated.
te opening or closing cycle has not ended.
VISUAL DIAGNOSIS
ning and closing, the programming functions can be adjusted: motor force,
deceleration, etc.
14
MOTOR TIME
PS-300 13 sec.
PS-400 18 sec.
INT / INTOIL 23 sec.
SN-50 / SN-50B 16 sec.
-
-
-