Programming Functions - Key Automation 900CT-201 Manual De Instrucciones

FUNCTIONS \ VALUES
WORKING TIME M1
(seconds)
WORKING TIME M2
(seconds)
M1 DELAY TIME
(seconds)
AUTOMATIC CLOSURE
(seconds)
OPEN COMMAND
% DECELERATION
ELECTRIC LOCK HAM-
MERING
FLASHER OUTPUT
CONDOMINIUM
(OPENING ONLY)
MOTOR WARM-UP
(minutes)
MOTOR FORCE
N° OF MOTORS
CLOSE AFTER TRANSIT
TIMER/MAGNETIC COIL
ON STEP/STEP
SOFT START
ELECTRO LOCK / SCA
(open gate light)
DEAD MAN FUNCTION
PRE-FLASHING

PROGRAMMING FUNCTIONS

5 6 9
5 6 9
-- 0 1
NO 5 10
Open
Open By activating the step/step function, you avoid passage of the automation in the
Stop
Close stop state. The enabled function may be critical for automations with high inertia.
close
NO 10% 20%
If you select the Hammering parameter, the control unit facilitates the release of
NO YES
Courtesy
Flashing
light
NO YES
NO 15 25
100%
10% Min 20%
Max
2 1
When you activate the Close After Transit function with automatic closure activated, the
NO YES
automation is closed in the shortest time possible without waiting for automatic re-closing.
When you activate the function Timer / Magnetic Coil via parameter P after terminating
NO YES so that the gate never closes until the step/step contact is opened again, if there are
several step/step impulses during the standby time for automatic closing the time will be
NO YES
-- ELS SCA
When you activate the dead man function via parameter U, you can open the auto-
NO YES mation until step/step contact is closed and close the automation until contact PED is
NO 1sec 2sec
12 15 18
12 15 18
With this selection you can delay start-up of the
4 10
15 20 25
When the deceleration function is activated in the last seconds
30% of operation of the automation, the control unit slows the mo-
tors based on the selected %.
accepts only re-opening during closing
If you insert parameter I = from 1 to 3 and if the gate is standing
closed in standby at the end of the set time there will be a closure
of both doors of 1 min. at a value of power that does not damage
40
internal temperature of the electric motor at a point where ice does
not form in the mechanical reduction gear. This function should be
used when temperatures of less than 5°C are expected.
30% 40% 50%
Parameter of selection of automation with 1 or 2 motors
continuously reset
start.
The SCA function (open gate light) allows the connection of a 12Vac
4sec
15
21 24 27 30
21 24 27 30
second motor M1 by the set time
30 40 80 120
60% 70% 80% 90%
-
+3sec
+3sec
-