FALMEC DOWNDRAFT Manual De Instrucciones página 22

The 4° (4th) speed is timed; if the user does not change the speed, the motor
will remain in 4° (4th) for 14 minutes and then shift into 3° (3rd). The T5 key will
switch off and the T4 key will light up.
6: LIGHT - REMOTE BINDING
Light: Briefly pressing key T6 will turn the light on and off. The T6 key will light up if
the light is on. If the mobile part is closed, it will open, and the light will switch
on after a few seconds.
Remote Binding (optional): With motor and light turned off, applying prolonged pres-
sure on the T6 key will activate remote binding mode. The T6 Key will flash for
a maximum of 10 seconds. During flashing, at least one radio control key must
be pressed. The function will deactivate upon completion of the 10 seconds, or
earlier if a compatible remote control is detected.
KEY PRESSURE MANAGEMENT:
Prolonged pressure = finger pressed on key for at least 3 seconds, the function activates
during pressure.
Non-prolonged pressure = finger pressed on key for less than 3 seconds, the function
activates upon its release.
Radio control (optional): Place the device far from sources of electromagnetic waves
which could interfere with the range hood's electronic functions
Maximum operating distance 4 metres. This distance may vary in defect ba-
sed on electromagnetic interference of other devices.
Function of the
remote control
Light Key
' - ' Key
' + ' Key
Timer Key
Code Change
(only in case of
malfunction)
H
FILTERS
1. METAL FILTERS
Open the panel fixed to the body of the range hood with magnets (see ill.
H3). To remove the metal grease-trapping filter (A) pull on the filter handle.
20
Pressing the Light key will switch the light on/off
Pressing the '-' Key will decrease motor speed. If 1° (1st) speed is in
gear, pressing the '-' key will turn off the motor
If the motor is turned off, pressing the '+' key will activate the motor
at 1° (1st) speed. If the motor is operating, pressing the '+' key will
increase motor speed up to the maximum.
If the motor is active, pressing the timer key will activate/deactivate
the timer function
Press the "Luce" (Light) key together with the "Timer" key of the
remote control until the blue LED begins to slowly flash. If the "-" key
of the remote control is pressed within 5 seconds, the new code will
be generated and memorised. Memorisation is confirmed by 3 brief
flashes of the LED.
To return to the default code, apply pressure on the "-" key together
with the "+" key for over 5 seconds. Memorisation of the default
code will be signalled with 3 brief flashes of the LED.
Each time that a new code is generated or that the default code is set
in the remote control, it is necessary to also carry out the previously
described Remote Binding (Light Key of the pushbutton) procedure.
REMOVING AND REPLACING'S INSTRUCTIONS
DESCRIPTION