Fcc Compliance Statement - Epson LabelWorks LW-600P Manual Del Usuario

Ocultar thumbs Ver también para LabelWorks LW-600P:
Tabla de contenido

Publicidad

• Mantenga las pilas fuera del alcance de los niños. Si el ácido de las pilas le entra en los ojos o entra
en contacto con su piel, lave inmediatamente la zona afectada con agua y busque asistencia médica.
Si la pila fuera ingerida, busque asistencia médica inmediatamente.
• Si el ácido se derrama de una pila, límpelo con un paño y reemplace la pila con una nueva.
• Utilice pilas AA alcalinas.
• No utilice pilas nuevas y viejas juntas y no mezcle pilas de diferentes tipos.
• Introduzca las pilas para que coincidan con las marcas de polaridad (+ y –).
• Retire las pilas descargadas de inmediato.
• No caliente las pilas y no las tire al fuego o al agua.
• No retire las pilas con objetos de metal como pinzas o la punta de un bolígrafo.
• Siga los reglamentos locales sobre la eliminación de pilas.
Tema principal:

FCC Compliance Statement

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
Caution
Changes or modifications not expressly approved by the party responsible for compliance could void the
user's authority to operate this equipment.
An AC adapter with ferrite core must be used for RF interference suppression.
For United States Users
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio or television reception. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause interference to radio and television
reception, which can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
Instrucciones importantes de seguridad
111

Publicidad

Tabla de contenido
loading

Tabla de contenido