TRP COMPACT N&D Instrucciones De Montaje página 20

COMPACT N&D
EN
Glue EPDM gasket around hatch hole (see
3
detail for cutting end join edges).
HOW TO CUT EPDM GASKET
!
TO AVOID WATER FILTRATION
A- Glue gasket, keeping 100 mm of protection
paper at each side.
B- Remove the two pieces of paper.
C- Glue by pressing both ends.
B
Gasket
OUTSIDE CABIN:
4
Position Compact in sun hatch hole.
Caution! When positioning the unit above
the hatch gap, check that the wastewater
run-offs are not blocked by the EPDM
seal.
INTO THE CABIN
Gasket
Remove
3
A
Gasket
100 mm Approx. (protection paper)
C
Gasket
4
Sun hatch
20
®
15 mm
Gasket
Cabin roof
Gasket