Makita XBU02 Manual De Instrucciones página 5

NOTE:
The tool does not work with only one
•
battery cartridge.
Tool / battery protection system
The tool is equipped with a tool/battery
protection system.
automatically cuts off power to the motor to
extend tool and battery life.
The tool will automatically stop during
operation if the tool or battery is placed
under one of the following conditions. In
some conditions, the indicators light up.
Overload protection
When the tool is operated in a manner that
causes it to draw an abnormally high
current, the tool automatically stops without
any indication. In this situation, turn the tool
off and stop the application that caused the
tool to become overloaded. Then turn the
tool on to restart.
Overheat protection for tool
On
015485
When the tool is overheated, the tool stops
automatically, the battery indicator blink about
60 seconds. In this situation, let the tool cool
down before turning the tool on again.
Overdischarge protection
When the battery capacity becomes low,
the tool stops automatically. If the product
does not operate even when the switches
are operated, remove the batteries from the
tool and charge the batteries.
Remaining battery capacity
indication
1
015476
This
Blinking
1. Battery indicator
2. Check button
2
1
Press the check button to make the battery
indicators show the remaining battery
capacities.
correspond to each battery.
Remaining battery capacity indication
system
Battery indicator status
On
015527
Switch action
CAUTION:
Before inserting the battery cartridge into
•
the tool, always check to see that the
switch trigger actuates properly and returns
to the "OFF" position when released.
015478
To start the tool, simply pull the switch
trigger.
increasing pressure on the switch trigger.
Release the switch trigger to stop.
015479
5
The battery
Remaining battery capacity
Blinking
Off
Charge the battery
1
Tool speed is
1
1
indicators
50% - 100%
20% - 50%
0% - 20%
1. Switch trigger
increased by
1. Lock button