Front Control Panel; Rear Panel; Sockets Panel - Selco Quasar 35 Instrucciones De Uso

3.2 Front control panel

1 Power supply
Indicates that the equipment is connected to the mains
and is on.
2 General alarm
Indicates the possible intervention of protection devices
such as the temperature protection.
3 Power on
Indicates the presence of voltage on the equipment
outlet connections.
4 Overtemperature alarm
Indicates that the temperature protection device has
operated.
It is advisable not to switch off the equipment while the
alarm is on; the internal fan will thus keep operating
and will help to cool the overheated parts.
5 Torch hood protection alarm
Indicates any operation of the protection on the head
of the torch, which could be faulty or simply not prop-
erly screwed on.
6 Insufficient air pressure alarm
Indicates that the compressed air pressure is below 3.5
bar and therefore insufficient for correct operation.
7 Air test button
Allows the compressed air circuit to be cleansed of
impurities and the carrying out of the appropriate pre-
liminary pressure and compressed air flow adjustments,
without power on.
8 Main adjustment handle
Allows the cutting current to be continuously adjusted.
22

3.3 Rear panel

1 Air filter unit
2 Filter unit air connection coupling
3 Pressure reading gauge
4 Pressure adjustment knob
5 Power supply cable
Connects the system to the mains.
6 Off/On switch
Turns on the electric power to the welder.
It has two positions, "O" off, and "I" on.

3.4 Sockets panel

1 Torch fitting
2 Earth socket
Earth wire connector.