Vortice VORT HR 350 AVEL Manual De Instrucciones página 31

ENGLISH
Some examples of the HOME screen are shown below.
1
Ext + 5°C
Exh +18°C
Equipment start-up/shut-down (only NO UK markets)
Only NOT UK: If the equipment is switched off, the "HOME" page will display "Off" at the centre.
To access equipment: from the "HOME" page, press the [▲] key. ATTENTION: When the appliance is switched, both motors
will stop to allow repositioning of the by-pass valve. After, motors will start up again. During this period, "Off" still be
displayed and the User can not apply modifications.
To switch off the equipment: from the "HOME" page, press the [▼], until the following text appears: "Off". ATTENTION: After
selecting the Appliance off, indoor air is extracted at the max speed (about 3 minutes) to avoid condensate presence on
the heat exchanger. During this period, "Off" still be displayed and the User can not apply modifications.
Selecting speed
To increase the speed: from the "HOME" page, press the [▲] key until one of the following texts is displayed: "1", "2", "3" or
"Boost". Each text displayed corresponds to a different fan speed and thus a different air flow rate.
To decrease the speed: from the "HOME" page, press the [▼], key until is displayed: "1".
"Main menu" page
Press the [ ] button from the "HOME" page to go to a new page entitled "Main Menu."
From this new screen you can manage:
• Operations menu (allows some devices or some functions to be activated)
• Alarms (enables verification and management of any alarms)
• Configuration (lets you run weekly programming)
• Info (enables viewing of software versions)
Use keys [▲] and [▼] to move from one row to another. The selected row is highlighted in negative contrast.
Use the key [ ] to go to the highlighted page.
Use the key [X], to exit from a page without saving any changes.
MAIN MENU
USE MENU
ALARM
SETUP
INFO
Warning:
After 2 minutes with no keys being pressed, the display returns to the "Home" page without saving any changes.
"Operations menu" page
On the "Main menu" page, go to the "Operations menu" row and press the [ ] button. You will be asked to enter a password
which will enable access to a user menu and an installer menu. The credentials for access to them are as follows:
• 013 USER
• 023 INSTALLER
Bypass
Int +22°C
NoFrost
2
Progr
03/04/2017 12:30
MAIN MENU
USE MENU
ALARM
SETUP
INFO
31