Twin-Star International 23TF2322 Manual De Instrucciones página 5

10. Insert one Wood Dowel (N) into each of the
pre-drilled holes on the top edges of the
Assembly from step 9. Then locate
Mantel/Top (G) and lay fi nished side up on
top of completed assembly. From the inside,
attach Mantel/Top (G) using Bolts (L) and
Washers (M) through the pre-drilled holes in
the mounting blocks.
HAND TIGHTEN ONLY.
11. Using Phillips head screwdriver tighten all
Bolts alternating top and bottom, left and
right.
12. Locate Center Back Panel (I), attached to
the left back of the completed assembly
from step 11, using a Phillips Head
screwdriver, tighten screws (Q1) through the
pre-drilled holes in the Left Back Panel to
the completed assembly.
13. Locate Side Back Panel (P), attached to
the right back of the completed assembly
from step 11, using a Phillips Head
screwdriver, tighten screws (Q1) through the
pre-drilled holes in the Right Back Panel
to the completed assembly.
E-4
G
N
N
Q1
Q1
Center
Back
Panel
Mantel/Top
N
M
L
I
P
Side
Back
Panel
N