Overheating Protection; Technical Data; Guarantee - BOMANN FR 1206 CB Instrucciones De Servicio

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 13
4. Please note that the safety switch (1) is operated when the
control element is inserted into the guide mechanism.
5. Choose the right frying temperature and check the conditi-
ons of the food to be fried. A rule of thumb is that pre-fried
foods require a higher temperature than raw foods.
6. Do not carry or move the deep fryer if the oil or grease is still
hot.
7. When frying dough-like foods scrape off the excess dough
and put the pieces carefully into the oil.
8. Please ensure that the handle of the deep fat frying basket
has been correctly attached.
Press the ends of the wire together at the free end of the
handle.
Insert the brackets into wire hoops inside the basket.
The deep fat frying basket must not be more than 2/3
full. Do not overfi ll the frying basket (The maximum
fi lling quantity for chips is 200g per litre of oil/fat).
9. Rub dry humid foods with a cloth before frying.
Caution: In the case of foodstuffs which are too moist (e.g.
frozen chips etc.) large amounts of foam may form, which
under certain circumstances may cause the oil to overfl ow.
1. Make sure that the appliance is unplugged and switched off
(The control lamps are off.).
2. Take the lid off the deep fryer.
3. Remove the frying basket and fi ll the container with oil or
grease (maximum 3.3 l). The fi lling level must be located
between the minimum and the maximum level. Put the lid
back on.
4. Insert the plug into a 230 V, 50 Hz power socket. The green
control lamp (4) lights up. Set the desired temperature by
turning the temperature control (2).
5. The red control lamp (3) lights up. Once the set temperature
has been reached the red control lamp goes off. Place the
frying basket containing the items to be fried carefully into
the hot fat.
6. The red control lamp switches on and off several times
during frying. This is normal and it indicates that the
temperature is controlled by the thermostat and is being
maintained. Once the frying time is over (the frying times are
to be found on the packaging of the food or in the recipe),
please take out the frying basket.
7. Let the oil drip from the food being fried.
8. In order to switch off the machine, please turn the tem-
perature regulator to OFF and remove the plug from the
socket.Wind the mains lead up in the form of a spiral in the
cable compartment.
Cleaning
1. Make sure that the plug is pulled out.
2. Wait until the deep fryer is completely cool before cleaning.
Wait in any case for 1 to 2 hours after use before using
again to avoid burns.
3. In order to change the oil, pull the deep frying container out
by the handles andpour the oil out at the side.
4. Please do not immerse the device in water.
26
05-FR 1206 CB 26
Use
5. Clean the deep frying fat container, the lid and the
housing with a damp clothand household detergent if
necessary.Please do not immerse in water.
6. The deep frying basket can be cleaned in the usual way in
soapy water.
7. Avoid using abrasive materials or sharp objects. These may
damage the deep fryer!
Troubleshooting
Device is not working
Troubleshooting:
Check the mains connection.
Check the position of the thermostat.
Other possible causes:
The device is fi tted with a safety switch (1).
This prevents the heater being switched on accidentally.
Troubleshooting:
Check that the control element is correctly in place.

Overheating Protection

If you should accidentally switch on your deep fat fryer
when there is no oil or fat in it the overheating protection is
automatically turned on. The appliance is no longer ready
to be used. Unplug the deep fryer.
Only after the device has been left to cool down completely
should the „RESTART" button (9) on the rear of the control
element be operated in order to use the deep fat fryer again.
Please use a pointed object for this purpose.

Technical Data

Model: ........................................................................FR 1206 CB
Power supply:............................................................230 V, 50 Hz
Power consumption:..........................................................2000 W
Protection class:........................................................................... Ι
Filling quantity: .........................................................max. 3,3 Litre
This device has been tested according to all relevant current
CE guidelines, such as electromagnetic compatibility and low
voltage directives, and has been constructed in accordance with
the latest safety regulations.
Subject to technical changes without prior notice!

Guarantee

The device supplied by our Company is covered by a 24 month
guarantee starting on the date of purchase (receipt).
During the life of the guarantee any fault of the device or its
accessories ascribable to material or manufacturing defects will
be eliminated free of charge by repairing or, at our discretion, by
replacing it. The guarantee services do not entail an extension
of the life of the guarantee nor do they give rise to any right to a
new guarantee!
10.11.2006, 14:45:56 Uhr

Publicidad

Tabla de contenido
loading

Tabla de contenido