Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Installation on a Stand or Speaker Stand
1. Attach an appropriate TV pin to the top end of the stand
and fasten it with the handle at the side. Suitable TV pin: TV-
35 TV-pin for speakers, No. 60000735.
2. Loosen the fixation screws of the legs. Pull the legs out un-
til the cross struts stand at a 90º angle to the legs. Tighten the
fixation screws of the legs.
3. Install the speaker system via the flange on the speaker
stand or via the TV pin on the stand. Make sure that the maxi-
mum lifting height of the tube is never exceeded. The carrying
capacity of a stand or distance tube must never be exceeded.
•
Stand or satellite systems must only be installed on a
plane area with a maximum inclination angle of 5º.
•
When using stands or satellite system under the influence
of horizontal forces, e.g. through wind, the standing safety
can be impaired. This is why additional safety measures
like attaching ballast weights have to be taken.
•
If inclined tension cables or prolonged outriggers are
used, the area of danger has to be marked or even be
blocked.
•
Before lifting or lowering the telescopic tubes, you must
always block a safety area around the stand or satellite
system. This safety area must have a diameter of 1.5
times the maximum height.
•
Lifted telescopic tubes always have to be secured with a
secondary securing!
•
The total weight of the installation (=total weight of all
individual parts) must never exceed the maximum load
of the installation area.
•
The stand has to be installed out of the reach of the people.
•
An unintended movement of the load has to be avoided
– also in case of fire!
•
The installer is responsible for adhering to the carrying
capacity given by the manufacturer, the safety require-
ments and the qualification of possible co-workers.
•
When peaople are located below the load, all necessary
safety measures have to be taken in order to avoid injury.
BAM 10A UHF
ENGLISH VERSION
•
The personnel have to be instructed on the content of
the user manual and on the dangers related with oper-
ating stands.
•
Depending upon the individual installation spot, all nec-
essary measures against movement and for securing the
standing safety have to be created.
•
The installation is only allowed on carrying areas. In
some cases, an appropriate substructure, e.g. via a bal-
ancing foot, has to be created. When choosing the instal-
lation material, optimum dimensions have to be chosen
in the order to secure maximum safety.
•
Speaker systems installed on stands or satellite systems
may cause severe injuries when crashing! If installing on
slippery surfaces, the legs must be secured with screws
or nails via the provided holes or an anti-slippery mat
has to be used.
p. 9
Publicidad
Tabla de contenido
