Section 6. User Maintenance Instructions; Daily; Weekly; Monthly - Nature2 Fusion Inground Manual De Instalación Y Funcionamiento

Page 16
Section 6. User Maintenance Instructions
The following information describe how to care for your Nature

6.1 Daily

1. Filtration and Circulation. Follow the manufacturer's directions for keeping the circulating pump
in good working order and operate it at least six (6) hours a day. Consult your Nature
times. Check pool fi lter periodically, clean as recommended by manufacturer.

6.2 Weekly

1. Chlorine Test. Test pool water chlorine level with a reliable test kit. Maintain ideal range by adjusting the
Nature 2 Fusion chlorine production rate (see Section 5.4). Recommended free chlorine is 0.5 - 1 ppm. May be as
low as 0.5 ppm (0.6 ppm in Canada) with the use of a Nature
NOTE It is recommended that chlorine test samples be taken from two (2) places, one (1) at the pool return
line, the other well away from the pool return line. Compare the samples. A higher level should be found
at the pool return line. The higher level at the pool return line indicates the Nature
chlorine.
a. At the pool return line. a. At the pool return line.
b. 18" " (46 cm) below the surface and well away from the pool return line.
b. 18 (46 cm) below the surface and well away from the pool return line.
4. pH Level Test. Test the pH level of your pool with a test kit. If necessary, adjust according to your service
representative's recommendations. APSP standard of 7.4 - 7.6 is recommended.

6.3 Monthly

1. Pool Water Sample. Take water sample to local pool store for testing.
2. Total Alkalinity Test. Test pool water for total alkalinity with a test kit. Adjust according to your qualifi ed
service representative's recommendations. 80 - 120 ppm APSP Standard.
3. Stabilizer (Cyanuric Acid). Test pool water stabilizer (cyanuric acid) level using a test kit or by having a
water sample tested by a service representative. Maintain ideal range of 10 - 50 ppm. Follow your service
representative's recommendations. The addition of stabilizer is not necessary for indoor swimming pools.
4. Calcium Hardness. Test pool water for calcium hardness level using test kit or by having a water sample tested
by a service representative. If necessary, adjust according to your service representative's recommendations.
APSP standard of 175 - 400 ppm is recommended (for outdoor pools only).
5. Metals Test. It is recommended that the pool water be tested periodically for the presence of metals such as iron,
and manganese. These metals should not be present in the pool water. If those metals are present, contact your
local service representative.
6.4 Nature Mineral Cartridge Replacement
2
The Nature 2 cartridge for the Nature
length of time).
1. Shut off the pool pump and fi lter.
2. Close valves between fi lter and pool to prevent pool draining.
3. Turn large collar counterclockwise to remove and lift off cap.
4. Remove old cartridge and discard in household trash. Insert the new cartridge (see Section 4.3)
Nature 2® Fusion Inground Installation and Operation Manual
2 Fusion lasts six (6) months or one (1) pool season (whichever is the shorter
2 Fusion.
cartridge that is within its normal operating life.
2
dealer for optimum run
2
Fusion is producing
2