Truvox International ORBIS BATTERY SCRUBBER Manual Del Usuario página 11

9. Accessories
Item
Standard brush (black)
Soft brush (white)
Drive board
Squeegee front & rear blades PARA (1 pair of blades)
Squeegee front & rear blades PARA (5 pairs of blades)
Squeegee front & rear blades Anti-oil (1 pair of blades)
Squeegee front & rear blades Anti-oil (5 pairs of blades)
10. Fault diagnosis
The following simple checks may be performed by the operator:
Trouble
The machine does not
start up
The brush does not
rotate
Vacuum does not
work
The machine does not
dry well, leaving
traces of water
No water comes out
Insufficient floor
cleaning
* If the fuse blows several times, the machine should be checked by an authorised Service Agent.
Reason
• Low battery
• Main fuse blown*
• Brush unit outlet over-current error or
brush unit open circuit error
• Brush rotation button not pressed on
handle controls
• Vacuum motor over current error or
vacuum motor circuit error
• Vacuum button not pressed on handle
controls
• Vacuum off
• Vacuum tube blocked
• Squeegee rubbers not correctly set up
• Recovery tank full
• Squeegee rubber blades worn
• Tank empty
• Solenoid valve button not pressed on
handle controls
• Water regulation tap turned off
• Filter blocked
• Solenoid valve does not work
• Unsuitable brushes or detergent
• Brush worn
Part No. Usage
05-4621-0000 General purpose scrubbing
05-4622-0000 Light scrubbing
05-4620-0000 For use with pads
95-0048-00 Wet pick up on all types of floor
95-0049-00 Wet pick up on all types of floor
95-0050-00 Oil resistant squeegee blades
95-0051-00 Oil resistant squeegee blades
Remedy
• Check the battery is charged
• Replace the GREEN 30A main
fuse.
• See paragraph '3. Controls'
• Press the button
• See paragraph '3. Controls'
• Press the button
• Start the vacuum
• Check and if necessary clean the vacuum
tube that connects the squeegee to the
recovery tank.
• Set up the squeegee rubbers as indicated in
6.2 Squeegee set up
• Empty the recovery tank
• Replace or turn over the squeegee blades.
• Fill the tank
• Press the button
• Turn on the tap located at the bottom of the
machine
• Clean the filter
• Call the technical support service
• Use brushes or detergents which are
suitable for the type of floor or dirt to be
cleaned.
• Replace the brush.
10