Audiolab LIVE 24 XL Manual De Usuario página 28

the channel box and this will turn off indicating
their elimination.
After you edit the DCA group, press
the "DCA Set" button which is blinking,
either on screen or panel. Repeat the
above steps to edit other DCA groups. Each group
may be assigned repeatedly channels, for exam-
ple channel 3 could belong to DCA1 and DCA2 at
the same time, etc. After selection finished, the
system will return to the page "Mixer" automat-
ically, in which page you can operate selected
group. You can slide fader on the left of screen to
increase or decrease the channel fader levels (not
volume) in proportion at the same time, or by ro-
tating the corresponding knob to control the level.
Pressing this button a warning box will
be displayed on the screen, which must
be confirmed if you desired clear the
channel selection of the respective DCA group.
Meters interface
This page gives you an overall review of all input
and output channels and buses' meters status.
Please note that this interface is not adjustable.
If you want to adjust volume, you can achieve it
in the Long Fader or Routing interface, or directly
press the corresponding channel buttons.
P. 28
AUDIOLAB Live 24 XL -
English version
This icon indicates current channel's fad-
er position, "0" is zero dB position.
The number above it shows level of
current channel.
This icon on the right shows the actual input
signal level activity.
This icon on the left shows LIMITER/COMP
meters.
Routing interface
You can select input channels of Main 1-24 and
FX1-2 route them to output channels of Main,
Aux 1-8 and FX1-2. For example, below window
shows Aux 1 routing function. In this page, you
can route input channels in LCD screen to Aux1
output. In Main routing page, channel level can
not be adjusted, but channel level in Aux and FX
pages are adjustable. As the function of this but-
ton will be a little bit different in different control
please notice the notes that are shown on the
LCD screen when operating.
Touch it to route input channel 1 to output
AUX1 as an example. Please rotate Param-
eter Adjust knob or slide long fader on the
screen to change selected channel's audio
level. Touch PRE on the screen, it will switch to