Twin-Star International 26TF8299 Manual De Instrucciones página 6

3. Insert one Wood Dowel (KK) into each of the
pre-drilled holes on the top edges of the Assembly
from step 2.Then locate Media Top (G) and lay
finished side up on top of completed assembly From
the inside, attach Media Top (G) using Bolts (AA)
and Washers (BB) through the pre-drilled holes in
the mounting blocks.
HAND TIGHTEN ONLY.
Using Phillips head screwdriver tighten all Bolts
alternating top and bottom, left and right.
Hardware Used
AA Bolt
BB Washer
KK Wood Dowel
4. Locate Center Back Panel (J), using a Phillips Head
screw driver,tighten screws (DD) through the
pre-drilled holes in the Center Back Panel to the
completed assembly.
Locate Left Back Panel (I), using a Phillips Head
screw driver,tighten screws (DD) through the
pre-drilled holes in the Left Back Panel to the
completed assembly.
Hardware Used
Screw
DD
5. Connect the Right Front Door (M) to the Right Side
Panel (F) with the hinge pre-installed on the door,
then use a Phillips head screwdriver to tighten the
Screws (EE) through the pre-drilled holes.
Attach the Handle (HH) to the Front Door (M), use
the bolts attached through the pre-drilled holes in
the door. Then use a Phillips Head Screwdriver to
tighten the bolts.
Repeat the other side.
There are levelers located under the mantel which
the height can be increased by twisting
counter-clockwise.
Hardware Used
Screw
EE
Handle
HH
(with bolt)
Fig. 3
x 8
x 8
x 8
Fig. 4
x 15
Fig. 5
x 12
x 2
5
G
KK
BB
AA
DD
I
J
M
HH
EE