Twin-Star International 26TF8299 Manual De Instrucciones página 8

9. Locate Right Inner Panel (O), using a Phillips Head
screw driver to tighten screws (FF) through the
pre-drilled holes.
Hardware Used
FF Screw
10. Open the Right Front Door (M) and cooler door,
connect the Right Front Door (M) to the cooler door
with Screws (JJ) and Door Clip (GG), Use a
Phillips Head Screw Driver to tighten Screws (JJ)
through the pre-drilled holes in the Door Clip (GG).
Close door and adjust the wine cooler forwards or
backwards to insure a smooth operation of the
door with a tight seal.
Note: Installing the clip with the door open at
a 45 degree angle will help insure a smooth
operation through the full motion of the door.
Hardware Used
Screw
JJ
11. Lacate the Positioning Panel (N), using a Phillips
Head Screw Driver to tighten Screws (FF) through
the pre-drilled holes.
Hardware Used
Screw
FF
Fig. 9
x 4
Fig. 10
x 2
Fig. 11
x 3
7
O
JJ
GG
N
FF
FF