Publicidad
General information:
The outdoor fi replace/garden grill has to be
assembled on compacted, leveled ground or
concrete. Make sure there is suffi cient clea-
rance (36 inches), between the unit and fl am-
mable material. Step #4: the refractor base is
an option when grilling (can be omitted), but
is mandatory for wood burning.
Using the outdoor fi replace/garden grill:
Start the fi re with a small fl ame; if unit is
exposed to extreme heat too quickly, cracking
of the parts might occur.
This is very important if the weather conditi-
on caused the concrete parts to become wet.
However, if cracks should occur, it would not
dimish the function of your outdoor fi replace/
garden grill, because all components are
metal re-enforced. The occurrence of hairline
cracks in the refractor parts are possible, but
do not constitute a claim.
Recommended burning materials:
The outdoor fi replace/garden grill is made
for usage of either charcoal or fi re wood
only!
Do not use more than 10 lbs of charcoal or
wood at one time!
Use only recommended starter fl uid or kind-
ling!
Do not use kerosene or gasoline, or similar
liquids to light the charcoal/fi rewood!
Attention:
Do not overheat the outdoor fi replace/garden
grill!
Assembly:
After you have levelly installed base plate ➀,
the rest of assembly is carried out according
to the drawing using parts ➁ - ➆. Please
make sure you follow this sequence!
The metal hood is fastened in the middle of
the cover plate with the clamp. The hood is
height adjustable.
All parts of the fi replace are to be connected
with the enclosed start-up adhesives at least
locally.
Please make sure the barbeque fi replace com-
ponents excepting cover plate ➆ are placed
fl ush to each other on the rear side. Cover
plate ➆ is mounted towards the rear with a
slight overlap.
Disassembly:
A possible disassembly of the garden bar-
beque fi replace is to be carried out in the
reverse sequence.
Included:
1 bag of start-up adhesives
Cleaning:
The surface of your outdoor fi replace/garden
grill can be cleaned with either a high pressure
power washer, or diluted bleach and coarse
brush.
The copper/stainless steel hood, will show a
green patina after a period of time, which is
normal, but can be cleaned with copper or brass
cleaning material, if so desired.
English
Publicidad
