Tru-Test WaterPro 2 Guía De Instalación Y Servicio página 12

d Take the measurement and subtract 8.75 inches (222.3 mm) from this number. This is the amount of pipe you will need to
cut.
e Remove all adapters and fittings from the vertical water supply line.
f From the top down, mark the pipe with the measurement you need to cut. Cut the pipe.
g Attach any adapters and the ½ inch NPT fitting and re-measure. The distance from the top of the concrete to the top of the
NPT fitting should now measure 8.75 (222.3 mm) inches. Once this is confirmed, permanently attach your adapters and
fittings.
h Turn on the water supply to flush any dirt and debris through the water supply line. Turn off the water supply.
i To test for leaks throughout the entire system (including the valve), remove the valve and mount assembly, attach the ½
inch flex line to the shut-off valve and to the vertical water supply line. (The ½ inch flex line is pre-installed on some
units). Turn on the water and check for leaks. Turn off the water.
j Undo the shut-off valve from the ½ inch flex line.
k Slide the water supply insulation tube over the ½ inch flex line and vertical water supply line. Both should be insulated.
12