HQ-Power ARAZU I Manual Del Usuario página 5

• DMX512 Control
Operating the ARAZU I through a DMX controller allows you to create your own tailored programs and to control
each connected ARAZU I individually. Simply connect the controller to the ARAZU I using a standard DMX cable.
Press MODE until R.XXX is displayed. Next, set the DMX address for each ARAZU I.
o Detailed DMX Values per Channel
CHANNEL
1
2
3
4
5
o DMX512 Connection
Connect the provided XLR cable to the female 3-pin XLR output of your controller and the other side to the male 3-
pin XLR input of the ARAZU I. Multiple ARAZU Is can be linked through serial linking. The linking cable should be a
two-core screened cable with XLR input and output connectors.
o DMX512 Chain with Termination
o DMX Start Address
All DMX-controlled devices need a digital start address so that the correct device responds to the signals. This start
address is the channel number from which the device starts to "listen" to the DMX controller. Enter the correct
number and read it from the display located on the base of the ARAZU I.
VDPL300SC
FUNCTION FROM
Shutter
Gobo
104
112
120
128
Gobo rotation
Pan
Tilt 136
140
A DMX terminator is recommended for installations where the DMX cable has to run a
long distance or is in an electrically noisy environment (e.g. discos). The terminator
prevents corruption of the digital control signal by electrical noise. The DMX terminator is
simply an XLR plug with a 120
the XLR output socket of the last device in the chain.
Please see illustrations.
TO DESCRIPTION
0 255 From 0 to 100 %
0 7 Gobo 1
8 15 Gobo 2
16 23 Gobo 3
24 31 Gobo 4
32 39 Gobo 5
40 47 Gobo 6
48 55 Gobo 7
56 63 Gobo 8
64 71 Gobo 9
72 79 Gobo 10
80 87 Gobo 11
88 95 Gobo 12
96 103 Gobo 13
111 Gobo 14
119 Gobo 15
127 Gobo 16
255 Gobo changing
0 255 From 0 to 100 %
0 255 From 0 to 100 %
0 135 Forwards rotation from 0 to 100 %
139 Stop
255 Backwards rotation from 0 to 100 %
resistor between pins 2 and 3, which is then plugged into
5 HQPOWER