Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
oPerAtion - general
The appliance is intended only for domestic use,
not for professional use.
1. Comb attachment 1 (3 mm)
2. Comb attachment 2 (6 mm)
3. Comb attachment 3 (9 mm)
4. Comb attachment 4 (12 mm)
5. Power cord and plug
6. Oil
7. Small brush
8. Cutting comb
9. Adjusting lever for cutting comb
10. Comb
11. Scissors
12. Trimmer
13. On/Off switch
14. Protective cover for cutting comb
oPerAtion - Before use for the first time
1. Make sure the On/Off switch is set to 0 (Off).
2. Remove the plastic protective cover from the cutting comb.
3. Lubricate the cutting comb with a couple of drops of oil before using the appliance for the first time and
before using it on each further occasion.
oPerAtion - fitting comb attachments
The trimmer is supplied with 4 comb attachments that are used to trim the hair to one of 4 different lengths:
•
Comb 1 is used to trim hair to a length of 3mm.
•
Comb 2 is used to trim hair to a length of 6mm.
•
Comb 3 is used to trim hair to a length of 9mm.
•
Comb 4 is used to trim hair to a length of 12mm.
Using the clippers without a comb attachment will
cut off virtually all the hair. You can use the adjusting
lever on the side of the appliance (number 9 in
Figure 1) to set the cutting length between 0 and
3 mm.
1. Slide one of the comb attachments over the
head of the trimmer's fixed cutting comb (see
Figure 2).
We recommend that you use the largest comb
attachment when becoming familiar with the
appliance. You can always switch to a smaller
comb attachment if you think that your hair is
still too long.
triMMing - general
1. Put the plug in the wall socket.
2. Switch on the clippers by setting the On/Off switch to 1 (On).
3. Start trimming your hair. Move the clippers at an angle so that the comb attachment follows the contours
of your head/body. Instructions for trimming hair on various parts of the head are given below.
12
10
11
8
14
4
16
instruction manual
5
13
7
6
1
9
2
3
Publicidad
Tabla de contenido
