Trimming - Neck; Trimming - Back Of The Head; Trimming - Sides; Trimming - Finishing - Bestron APC4603 Manual Del Usuario

instruction manual
Do not use the appliance for more than 10 min.

triMMing - neck

4. Fit the required comb attachment, for example comb 1 (3 mm) or 2 (6 mm).
5. Keep the cutting comb face upwards, and trim the hair in your neck from the bottom.
6. Trim the hair in successive widths, and from bottom to top.
7. Move the clippers slowly so that the cutting comb trims all the hair. Slow trimming gives the best result.

triMMing - Back of the head

8. Fit the required comb attachment, for example comb 3 (9 mm) or 4 (12 mm).
9. Trim the hair on the back of the head by slowly moving the trimmer from the bottom to the top, against
the direction of growth.

triMMing - sides

10. Fit the required comb attachment, for example comb 1 (3 mm) or 2 (6 mm) and trim the hair on the
temples.
11. Use a short comb attachment for sideburns. Move the trimmer from top to bottom, with the cutting comb
facing downwards.
triMMing - top of the head (crown)
12. Fit a large comb attachment, for example comb 3 (9 mm), 4 (12 mm). Obviously you can always use a
smaller comb attachment if you require shorter hair.
13. Trim the top of the head by moving the trimmer from the back to the front, against the direction of growth.
14. When the hair on the top of the head is very long you can use the comb to lift the hair whilst you use the
clippers to trim the hair above the comb.

triMMing - finishing

15. Using the clippers without a comb attachment will enable you to obtain a clean edge at the base of the
neck.
• Washing and drying your hair and then combing it thoroughly will make it more supple when you trim
it.
• Comb your hair before and regularly during trimming to make sure it remains in the required
model.
• Do not move the clippers too quickly; allow the cutting comb to pass through the hair without using
force. Comb your hair regularly during trimming to check that it has been trimmed evenly.

cleAning And MAintenAnce

Clean the clippers thoroughly after each use.
1. Remove the comb attachment, where relevant, from the clippers so that you can clean the appliance
thoroughly.
2. Use the brush to remove hairs from the trimmer head and from the cavity in the appliance.
3. Unscrew the fixed half of the cutting comb and clean the gap between the fixed and moving halves of the
cutting comb.
4. Clean the appliance with a clean damp cloth.
5. Lubricate the cutting comb with a few drops of oil supplied with the appliance.
6. Fit the plastic protective cap over the cutting comb, and store the clippers in its case.
• Do not use the appliance without the fixed half of the cutting comb fitted in place; the moving half of
the cutting comb could cause injury.
• Verify that the appliance is not connected to the power supply before you start to clean it.
• Never use corrosive or scouring cleaning agents or sharp objects (such as knives or hard brushes)
to clean the appliance.
17