Ingersoll Rand QX Serie Manual De Usuario página 22

EN
Fault
Category
Code
Motor Controller
E-12
Fault
Motor Controller
E-18
Fault
Motor Controller
E-1C
Fault
Motor Controller
E-1E
Fault
Parts and Maintenance
Original instructions are in English. Other languages are a translation of the original instructions.
Tool repair and maintenance should only be carried out by an authorized Service Center.
Refer all communications to the nearest Ingersoll Rand Office or Distributor.
EN-21
Notes
Early Trigger Release
Multi-step configuration did not
complete due to early trigger release.
Low Battery Fault
Motor controller is going to sleep
due to idle timeout (Fault is ONLY
displayed if the tool is connected via
USB).
Actions/Solutions
The trigger was released before the cycle
completed.
Cycle failed during one of the early stages of a
prevailing torque strategy. Retry or check the
joint for problems.
The tool will still operate properly. This is a
warning that the battery voltage is almost
drained. Replace or re-charge the battery.
Pull trigger to power-up tool.
48619852_ed2