BEROTEC MOFESSOR Manual Del Usuario página 16

B E R O T E C
A p p l i c a t i o n n o z z l e
The application nozzle is made of copper and can be bent into position. The nozzle
must not be bent, kinked or shortened in very tight radii (capillary tube).
P o s s i b l e i n s t a l l a t i o n v a r i a n t s :
» Lateral contact with the chain wheel
• Most visible mounting
• Rotating movement of the chain wheel
transports the oil onto the chain rollers
» Lateral contact with the sprocket
• Concealed and protected installation
possible
• Rotary movement transports the oil
onto the chain rollers
» Direct oiling of the chain
• Oil application necessary on the inside
of the chain
• Easy to install
The best installation location always depends on the motorbike and should be chosen
so that safe mounting is possible.
A nozzle mounting clip, a self-adhesive nozzle holder with clamping screw and self-
adhesive hose holder are supplied for fastening and hose installation. The oil hose is
clicked into the hose holders. The clamping screw of the nozzle holder serves to lock
the nozzle position. The surface to be bonded must be degreased. Curved surfaces are
unsuitable. The application temperature is at least 20°C.
16
MOFESSOR
NOTE: Nozzle can be damaged
if the wheel is not changed
properly
NOTE: The higher speed at the
pinion may lead to higher oil
consumption
NOTE: Oil pollution possible due
to air turbulence of the freely
dripping oil
Damage to the nozzle possible
due to chain slamming
English