Setting The Clock And Delay Brew Time; Preparing For Use; Suggested Coffee Measurement Chart - Mr Coffee KNX Serie Manual Del Usuario

SETTING THE CLOCK AND DELAY BREW TIME

To Set the Clock:
1. Plug the power cord into a
standard electrical outlet. The
clock will flash on the control
panel to indicate that the time
has not been set yet.
2. Press and hold the HR./MIN.
button until you reach the
current time. The AM and PM
will light up on the left side of
the display (Figure 1).
NOTE: Pressing any button before
setting the clock will cause the
clock to start keeping time from
12:00 a.m. You must set the clock
if you want to use the Delay Brew
feature.
To Set the Delay Brew Time:
While the display is in the clock
mode, simply press the SET DELAY
button (Figure 2) and, while the
Delay Brew Indicator LED is flashing,
set the brew time by pressing the
HR./MIN. button. The AM and PM
will light up on the left side of the
display (Figure 3).
Press the SET DELAY button to set the time. The display will
change to the current time.
NOTE: To activate the DELAY BREW cycle,
see the "Brewing Coffee Later" section.
To check the programmed time, push the SET DELAY button.
The display will show the time you have programmed the
coffee to brew. If you press the SET DELAY button again or
wait a few seconds , the display will switch back .
BVMC-KNX_16ESM1.indd 11-12
Figure 1
Figure 2
Figure 3
10

PREPARING FOR USE

Selecting and Measuring Ground Coffee:
For best results, use a level tablespoon for ground coffee
measurement.
Make sure you use medium grind coffee for a perfect brew.
A. Suggested Coffee Measurement Chart:
To Brew Ground Coffee
12 Cups 9 tbsp.
10 Cups 7.5 tbsp.
8 Cups 6.5 tbsp.
6 Cups 4.5 tbsp.
4 Cups 3 tbsp.
1 level tablespoon
(tbsp) = 5 gr./0.17 oz.
1 cup = 5 fl. oz. of
brewed coffee
Use more or less coffee
to suit your taste.
11
4/1/16 9:42 AM