Pioneer SE-MS9BN Manual De Instrucciones página 5

5. Using NFC for pairing
When a smart phone or tablet device is equipped with NFC, Bluetooth pairing
(and depairing) can be performed simply by merely swiping the device over the
headphones.
• Depending on the smart phone or tablet device used, the NFC signal reception
may be too weak to perform one-touch connections. The unit may pair with a
device other than the desired one if multiple NFC devices are nearby. In that
case, follow the manual pairing procedure outlined in step 4.
How to set pairing
(1) Hold the ( ) button depressed while the unit's power is turned off to
enter the pairing mode.
(2) Swipe the "N-mark" on the device to be connected about 1 cm above the
"N-mark" on the left side of the headband.
R
L
(3) The device will automatically begin setting the pairing.
• When the LED lamp is flashing in blue slowly about once every 3 seconds, pair-
ing is complete. When it is flashing quickly about once every second, pairing is
not complete.
* Only one device can be connected at a time.
Disconnecting
With connecting to this unit, swipe the "N" mark on the device to be connected
about 1 cm above the "N-mark" on the left side of the headband.
The connection will be automatically undone.
Depending on the specifications of the connected Bluetooth device, the connection
cannot be terminated from the NFC device. In that case, perform the procedure of
"Disconnecting from the Bluetooth device" in "4. Pairing".
5
En