BFT TIR 60 Instrucciones De Uso Y De Instalacion página 14

ENGLISH
21) ACCESSORIES
SM1 External unlocking to assemble to the existing cremone bolt of the
overhead door (fig. 22).
SET/S External unlocking with receding handle for sectional doors max.
50mm (fig. 23).
PT1 1 m extension for garage doors up to 3.50m (fig. 24).
APT Extension and bracket attachments for spaced or close to ceiling
assembly (fig. 25).
ST Automatic unlocking of bolts for spring overhead doors. Applied
to the control arm, it unhooks the side bolts of the door
automatically (fig. 26).
22) SCRAPPING
Warning! This operation should only be carried out by qualified personnel.
Materials must be disposed of in conformity with the current regulations.
In case of scrapping, the automation devices do not entail any particular
risks or danger. In case of materials to be recycled, these should be sorted
out by type (electrical components, copper, aluminium, plastic etc.).
23) DISMANTLING
Warning! This operation should only be carried out by qualified personnel.
When the automation system is disassembled to be reassembled on
another site, proceed as follows:
• Disconnect the power supply and the entire external electrical installation.
• In the case where some of the components cannot be removed or are
damaged, they must be replaced.
The descriptions and illustrations contained in the present manual
are not binding. The Company reserves the right to make any alterations
deemed appropriate for the technical, manufacturing and commercial
improvement of the product, while leaving the essential product
features unchanged, at any time and without undertaking to update
the present publication.
14 -
TIR 60-120 - Ver. 04
INSTALLATION MANUAL