Technical Data - Urrea HG865 Manual De Usuario Y Garantía

NO OR LOW PRESSURE
(after period of normal use)
Worn seal or packing. Worn or obstructed
valves. Worn unloader piston. Worn E-Z start
valve. Have parts cleaned or replaced by au-
thorized dealer.
WATER LEAKING AT SPRAY GUN/SPRAY
WAND CONNECTION
Worn or broken O-ring: Check and replace O-
ring.
Loose hose connection: Tighten hose connec-
tion.
WATER LEAKING AT PUMP
Loose connections: Tighten hose connection.
Piston packings worn: Have parts cleaned or
replaced by authorized dealer.
Worn or broken O-rings: Have parts cleaned or
replaced by authorized dealer.
Pump head or tubes damaged from freezing:
Have parts cleaned or replaced by authorized
dealer.
OIL LEAKING AT PUMP
Oil seals worn: Have parts cleaned or replaced
by authorized dealer.
Loose drain plug: Tighten drain plug.
Worn drain plug O-ring: Inspect and replace
O-ring.
Worn fill plug O-ring: Inspect and replace O-
ring.
Pump overfilled: Check for correct amount.
Incorrect oil used: Drain and refill with correct
type and amount of oil.
Vent plug clogged: Clean vent plug. Use air
hose to free it of blockage. If problem persists,
replace vent plug.
PUMP PULSATES
Nozzle obstructed: See "Using Spray Wand"
section.
28

TECHNICAL DATA

POWER
DISPLACEMENT
MAXIMUM PRESSURE
MINIMUM FLOW FEED
HIGHEST TEMPERATURE
MOTOR ROTATION SPEED
TANK CAPACITY
WEIGHT
6,5 HP
196 cc
3 200 PSI (220 bar)
8,1 L/min
60˚C
3 500 r/min
4 L
37,6 kg (82,8 lb)