Electrical Connection; Switching On/Off; Instructions; Use - Profi Cook PC-WKS 1083 Instrucciones De Servicio

4. Check the device for any transport damage in
order to avoid hazards.
NOTE:
If there is any visible transport damage, contact
your dealer immediately. Do not operate the
device if damaged!

Instructions

Preparation
Before using for the first time, boil fresh water at
least three times in the appliance. Use only water
without any additives or ingredients.
Mains Lead
Completely unwind the length of mains lead that
you require from the bottom section of the base.
Please ensure that the mains lead does not be-
come tangled up.

Electrical Connection

Check whether the electrical voltage that you
intend to use is the same as that of the machine.
Details are to be found on the label on the base.
Connected Wattage
The total power consumption of this device can be
up to 2200 W. With this connected load a separate
supply line protected by a 16 A household circuit
breaker is recommended.
CAUTION: Overload!
• If you use extension leads, these should have
a cable cross-section of at least 1.5 mm².
• Do not use any multiple sockets, as this
device is too powerful.

Switching on/off

Switching on: Press the toggle switch down-
wards. The indicator light in the
switch lights up.
Switching off: Press the toggle switch upwards.
The indicator light in the switch
goes off.

Use

NOTE:
Always use fresh water.
1. Place the machine on a flat surface.
2. Press the button in the handle to open the
kettle.
3. Then fill in the water (max 1.7 Litre). You can
read the filling level on the water level indicator
of the kettle.
4. Close the lid.
5. Place the kettle flush on the base.
6. Only connect the machine to a properly in-
stalled safety socket.
7. Switch on the kettle by pressing the switch.
The control lamp in the switch will light up.
Pausing/ terminating operation
There are two options to interrupt the boiling pro-
cess or to terminate it:
• The appliance will shut off automatically after
the boiling process. The indicator lamp will go
out.
• Push the rocker switch upwards to finish op-
eration.
CAUTION:
Do not remove the appliance from the base
without shutting it off first.
The contacts on the base are not suitable for
disconnecting the power supply.
WARNING: Danger of scalding!
• When pouring the water out, keep the lid
closed.
• During operation the housing becomes hot.
Do not touch it and allow the device to cool
down before storing it away.
• Disconnect the power cord.
• Emptying the water container.
Mains Cable Take-up Device
The mains cable can be wound up on the base.
39