Electrical Connection; Instructions; Operation - Profi Cook PC-WKS 1013 Instrucciones De Servicio

8 Function buttons
Reduce temperature
Increase temperature
9 Water level indicator
10 Spout

Electrical Connection

Power Requirements
The appliance can consume 2200 W of power in
total. At this power rating we recommend a sepa-
rate lead with fuse protection through a 16 A circuit
breaker.
CAUTION: OVERLOADING!
Do not use extension leads or multiple sockets
since this appliance is too powerful.
Connection
• Before plugging the mains plug into the socket,
check if the mains voltage which you want to
use matches that of the appliance. The details
can be found on the name plate on the base.
• Only connect the appliance to a properly
installed earthed 220 – 240 V~, 50 Hz socket.

Instructions

• When connecting to the outlet a buzzer sounds
twice. If the kettle is not on the base Standby
mode will be shown on the display. If the kettle
is on the base, the temperature measured in
the kettle is shown on the display.
• You hear several beep tones when removing
the water kettle from the base. The appliance
returns to standby mode.
• This appliance comes with a function to set the
optimum water temperature for your beverage.
• If selecting "C Boil water to 100°C, cool
down to 90°C to 60°C and keep warm" it
can take a moment until the set temperature is
reached, thanks to the excellent thermal proper-
ties. This also depends on the amount of water
and the set temperature. You can shorten this
process by opening the lid with button (3) after
the water has boiled.
Preparation
Before using for the first time, boil fresh water at
least three times in the appliance. Use only water
without any additives or ingredients.
NOTE:
Always use fresh water.

Operation

1. Place the machine on a flat surface.
2. Opening the Lid
Press the (3) button. The lid opens up.
3. Then fill in the water (max. 1.7 Litre).
You can read the filling level on the water level
indicator of the kettle.
4. Press down on the contact area (1) to close the
lid. The lid must audibly lock into place.
5. Place the kettle flush on the base.
Operation
A Boil water to 100°C
• Press the ON/OFF button. The button lights
up. The temperature increase is shown on
the display.
• The heating element automatically switches
off after reaching the temperature. You will
hear three beep tones. The indicator lamp
of the ON/OFF buttons turns off.
B Heat water to 60°C to 90°C and keep warm
• Press the or button. Set the desired
temperature with the buttons. The tem-
perature setting can be changed in steps
of 10°C. The selected temperature flashes
fast on the display. If you do not start the
process with the ON/OFF button within
5 seconds, setting mode is cancelled. The
temperature measured in the kettle is again
shown on the display.
• Press the ON/OFF button. The button light
flashes slowly. The temperature measured
in the kettle is again shown on the display.
The temperature rise can be seen later on
the display.
37