Further Performances Of The Machine Featuring An Engine - IPCGansow 1202 Manual De Instrucciones

ENGLISH (
Translation of original instructions)
MPORTANT:
DO NOT RUN THE MACHINE WHILE THE BIN IS RAISED, EXCEPT FOR THE MANOEUVRES NEEDED TO MOVE
THE BIN TOWARDS OR AWAY FROM THE WASTE CONTAINER.
Before pushing the machine when it is off or without its batteries, first turn the key to
deactivate the electric traction motor.
Turn and possibly remove the red key inside the battery compartment, as shown in the
figure hereby: this operation will disable the self-braking function of the machine.
USING THE WORK PROGRAMMES
After turning on the machine and starting the engine, if necessary, choose among the three available programmes, the
one best suiting your requirements by pressing one of the three keys.
BUTTON 1 " C " (Light cleaning, indoors, concrete, quartz, smooth floors, etc.)
BUTTON 2 " D " (Medium cleaning, carpet or other surfaces)
BUTTON 3 " E " (Heavy duty cleaning, outdoors, asphalt or rough surfaces with rubble, etc.).
NOTE: the parameters of programmes 1, 2 and 3 are factory set. To modify any of the settings, contact the retailer's
service centre.
Adjust maximum forward movement speed according to the working conditions.
Lower the left and/or right side brush by pulling out and lowering the relevant knob.
NOTE: the relevant left or right indicator light will come on.
To move the brushes back to their OFF position, pull up the knobs.
The speed of the side brushes can be changed using the adjustment knob shown in the figure.

FURTHER PERFORMANCES OF THE MACHINE FEATURING AN ENGINE

The version featuring an engine can guarantee the same working efficiency even when the motor is off, for instance
when the fuel has run out or when working in closed environments.
The working autonomy, in this case, will depend on the capacity (Amperes/hour) of the batteries installed, on the
intensity of the work programme chosen and on the battery charge status.
To guarantee the working life of the batteries, the machine features some safety systems:
1- When the battery voltage drops below 20.3 Volt, all machine functions, with the exception of the traction system, are
automatically stopped. When this situation occurs, recharge the batteries or turn on the engine.
2- Protection against excessive battery charging
Being fitted with a current generator featuring an electronic circuit, that acts as voltage regulator, the machine can
correctly charge the battery without damaging it with an excessive charge.
In fact, when the battery has been properly charged, it will except no further charging energy.
3- Using the machine with a battery or engine
Further to the tests effected and the results obtained from the evaluation of the energy consumption of our hybrid
system, we can affirm that Genius 1202 DP can work autonomously. In other words, the machine does not have to be
stopped to recharge the set of batteries (140 Ah). Tests have been made with all three programmes at the user's
disposal, namely P1, P2 and P3, on asphalted surfaces and normal slopes, and the sweeper has worked autonomously.
However, being the machine designed also for heavy duty working conditions (slopes of over 16%, extremely rough
surfaces to clean), the batteries may need to be recharged.
In this case, we recommend the use of an intelligent battery charge with a IUIa charging curve and a final proportional
charge, appropriately designed for this kind of machine and of a suitable size for the battery installed.
6