Candy FREESPACE Instrucciones Para El Usuario página 6

ASSEMBLING YOUR CLEANER:
Remove the cleaner and accessories from their packaging. Please dispose of the
packaging material in a safe and conscientious way.
Insert the hose end into the cleaner, ensuring it clips and locks into position.
To release: simply press the two buttons on the hose end and pull (P1).
Fit the hose/handle and floor nozzle onto opposite ends of the telescopic tube (P2 &
P3). The accessory tools can be stored on the tool holder clipped to the telescopic
tube (P3).
USING YOUR CLEANER:
Power supply - Pull cord and plug into power supply (P4). Please make sure the
cord is fully extended before using the cleaner. Press the on/off pedal once to start
the cleaner (P5). Press it again to stop the cleaner before removing the plug after
use. Press the cord rewind button to wind the power cord back into the cleaner (P6).
Fixed power control (depending on model) - Adjust the suction by moving the
handle valve: suction will decrease when opening the valve (P7). Use low suction for
delicate fabrics.
Variable power control (depending on model) - Slide the variable power adjuster to
increase or decrease the suction (P8). Use low suction for delicate fabrics.
Telescopic Tube - The telescopic tube can be extended in length when required
by sliding the tube latch forward to release the extension tube. The extension tube
can then be pulled out to the desired length (P9).
Carpet & Floor Nozzle - Press the pedal on the nozzle to lower the brush head
when cleaning hard floors (P10). Press the pedal again to lift the brush head when
cleaning carpets.
Mini Turbo Nozzle (depending on model) - Use the mini turbo nozzle (P11) for deep
cleaning on textile surfaces. Important: do not use the Mini Turbo Nozzle on rugs with
long fringes, animal hide and with carpet piles deeper than 15mm. Do not keep the
nozzle stationary while the brush is rotating.
Multifunction Tool - (P12) This tool can be used as:
1. Crevice tool: for corners and hard to reach areas
2. Dusting brush: for bookshelves, frames, keyboards etc.
Furniture Nozzle (depending on model) - For soft furnishings and fabrics (P12).
Parking and storage - The extention tube can be parked for temporary storage
during cleaning or in the storage position when not in use (P13 & P14).
Candy Bagged Standard.indd 2
2
GB
04/02/2008 17:04:16