Connection To External Devices - CAPITAL SPORTS INFINITY PRO 2.0 Manual De Instrucciones

CONNECTION TO EXTERNAL DEVICES

BT/ANT+ Establish connection
• Press the BT/ANT+ button on the control panel for 3 seconds until an
acoustic signal sounds.
• The mating lasts 40-60 seconds. The BT/ANT+ display flashes when
pairing. After the devices are connected, you can see your heart rate on
the console display.
• You can connect BT and ANT+ devices simultaneously.
• Press the BT/ANT+ button again to disconnect the devices.
• If you want to reconnect the devices, press the BT/ANT+ button again.
Note: If the connection takes too long to establish, deactivate BT on your
external device, activate BT and start a new connection attempt.
5 kHz connection
If your wearable delivers a 5 kHz signal, you will see your heart rate after
standing near the treadmill for 5 to 10 seconds.
Note: The BT/ANT+ function must be deactivated for the heart rate of the
wearable to be displayed.
EN
73