Onkyo TX-L50 Manual De Instrucciones página 57

> Before Start > Part Names
5. Hardware
■ 1. HDMI
HDMI CEC Setting to "On" enables the input selection link and other link
functions with HDMI connected CEC compliant device.
"On": Use this function
"Off (Default Value)": Do not use this function
When changing this setting, turn off and then on again the power
of all connected components.
0 Depending on the TV set, a link may need to be configured on
the TV.
0 Setting to "On" and closing the on-screen menu displays the
name of the CEC-compatible components and "CEC On" on
the display of this unit.
0 Power consumption in standby mode may increase if "On" is
set. (Depending on the TV status, the unit will enter the
normal standby mode.)
0 If you operate the volume dial on the unit when this setting is
"On" and audio is output from the TV speakers, audio will be
output also from the speakers connected to the unit. If you
want to output from only either of them, change the unit or TV
settings, or reduce the volume of the unit.
0 If abnormal operation occurs when you set the setting to "On",
set it to "Off".
0 When connecting a non-CEC compatible component, or when
you are not sure whether it is compatible, set the setting to
"Off".
56
> Install > Initial Setup > Playback
HDMI Standby When this is set to anything other than "Off", you can play the
Through video and audio of an HDMI connected player on the TV even if
the unit is in standby mode. Only "Auto" and "Auto (Eco)" can be
selected if "HDMI CEC" is set to "On". If you select anything
else, set "HDMI CEC" to "Off". (Default Value is "Off")
0 Power consumption in standby mode increases if set to
anything other than "Off".
"BD/DVD", "CBL/SAT", "GAME", "STRM BOX", "CD", "TV",
"PHONO": For example, if you select "BD/DVD", you can play
the equipment connected to the "BD/DVD" jack on the TV even if
the unit is in standby mode. Select this setting if you have
decided which player to use with this function.
"Last": You can play the video and audio of the input selected
immediately prior to the unit being switched to standby on the
TV. When "Last" is selected, you can switch the input of the unit
with the remote controller even in the standby mode.
"Auto", "Auto (Eco)": Select one of these settings when you have
connected equipment that conforms to the CEC standard. You
can play the video and audio of the input selected on the TV,
irrespective of what input was selected immediately prior to the
unit being switched to standby, using the CEC link function.
0 To play players on the TV that do not conform to the CEC
standard, you will need to turn the unit on and switch to the
relevant input.
0 When using TV that complies with the CEC standard, you can
reduce the power consumption in standby mode by selecting
"Auto (Eco)".
Advanced Setup | Firmware Update | Others
E
N