Set-Up Procedures; Start-Up Procedure - Sima SPIRAL-26 Manual De Instrucciones Original

1. SET-UP PROCEDURES

1.1 Level the machine on a flat and sound ground (Figure 1).
1.2 Made the power connection by a qualified electrician.
Note: Power Connection
1.3 Plug on the power supply cord of 5x4 mm
1.4 Grounding is to be made for safety. Do not operate the machine without grounded power
Grounding Connection: Follow the procedure below. Connect one end of the ground cable to
a copper wire (minimum16 mm) so as to ensure electrical conductivity. The other end of the
cable is to be connected to a tube having ability of conductivity dipped sufficiently into the
ground (into the damp soil, preferably), or to a copper plate buried under the soil as deeper as
possible.
FIGURE 1
1.2. START UP PROCEDURE
1.2.1 Check and ensure that the machine is installed in accordance with instructions.
1.2.2 Remove all parts (including bending apparatus) from the top surface of the machine.
1.2.3 Turn the switch (LEFT/STOP/RIGHT) to the LEFT or RIGHT, and the switch (MAN-
AUTO) to the MAN position, and determine the direction of rotation of the machine by pressing
the food pedal down.
Note: The clockwise rotation is accepted as the right rotation and the counter clockwise
rotation as the left from the front view (the control panel side) of the machine. If the machine
rotates counter clockwise in comparison to the turning direction of switch, it means that the
phases of power network are reverse. This situation will not create any problem for the
operation of machine. In such cases, you may turn the control switch (LEFT/STOP/RIGHT) to
the LEFT or RIGHT.
1.2.4 Start to make bending adjustments by following determination of rotation.
.
2
to the feeding line of main power.
4
.