Getting Started; Inserting The Batteries; Charging The Batteries - Pioneer SE-DRF41М Manual De Instrucciones

02 Getting started

2-1 Inserting the batteries

1 Remove the headphones' right (R) side
ear pad in the direction of the arrow
(see illustration 2-1.1).
2 Confirm the "+" and "–" poles and insert
the batteries as shown in illustration 2-
1.2.
3 Replace the ear pad in its original
position.

2-2 Charging the batteries

1 Connect the supplied AC adaptor to DC
IN jack on the transmitter.
Plug the adaptor into the wall outlet.
2 Mount the headphones on the
transmitter so that the headphones'
charging contacts align with the
contacts on the transmitter as shown in
illustration 2-2.2. When charging
begins, the transmitter's POWER/
CHARGE indicator will light red. When
charging is completed, the indicator will
go out.
3 The rapid recharge function will allow
complete charging within six hours. A
full battery charge will allow the
headphones to operate about twelve
hours.
• Usage time may vary according to the
temperature and other conditions.
• Do not place metal objects near the
headphones' charging contacts, since
dangerous electrical shorts or abnormal
heating may result.
Notes on battery charging
• Battery performance is influenced by the
surrounding temperature. Charge the
supplied rechargeable batteries within a
temperature range of 10 to 35 degrees celcius.
• Do not overcharge batteries. In order to
protect batteries, do not repeatedly charge the
batteries that are already fully charged.
• Batteries become slightly warm when
charging. This is not a malfunction.
• Use only the supplied AC adaptor with this
unit. Using other AC adaptors may cause
malfunction.
• For your safety, only the supplied rechargeable
batteries can be charged by this unit. Other
types of rechargeable batteries and dry-cell
batteries cannot be charged.
• Rechargeable batteries should be replaced
with new ones when they last only a short time
after recharging. New batteries can be
ordered from your nearest Pioneer service
center.
2-3 Connecting up
1 Connecting the transmitter to
audio sources
Use the furnished audio cable to connect the
transmitter's AUDIO IN jacks to the
earphones output connector on a TV, portable
audio player, or other audio playback
component.
If the playback component's audio output
utilizes a 6.3 mm headphone jack, use the
furnished plug adapter.
2 Connecting the transmitter to
AC adaptor
Connect the supplied AC adaptor to DC IN
jack on the transmitter. Plug the adaptor into
the wall outlet.
The transmitter's green indicator will flash for
approximately five seconds, then switch to
steadily lighted green, indicating that the
transmitter has established communication
with the headphones.
• Use only the supplied AC adaptor.
Using other adaptors with different plug
polarity or other characteristics can cause
product failure.
• Even AC adaptors with the same voltage and
plug polarity can damage this product due to
the current capacity or other factors.
5
En