Gima 27600 Manual De Uso Y Mantenimiento página 7

The product is planned for the use in closed environment as aid for hospital patients. Its max. capacity
is 145 Kg, calculated with the bedspring completely in horizontal position (head lift and legs lift
completely lowered).
The product or its components cannot be used for purposes different from the one specified in the
present manual.
Place the patient carefully on the bed only after providing for a suitable mattress and with the bedspring
completely in horizontal position everywhere.
Do not use stiff mattresses (it is advisable to use mattresses suitable for articulated beds)
Move the beds without wheels by lifting them from the floor.
If the bed is equipped with wheels, make sure that the wheels are not braked before moving it.
The product cannot be used on open spaces.
Do not use the equipment in case it is damaged. Apply to your retailer.
Avoid precarious repairs. Repairs shall be carried out with original spare parts only,
which shall be installed according to the intended use.
Since the product is made of corrosion-proof materials suitable for the enviromental conditions foreseen
for its normal use, does not require special care, however it is necessary to store it in a closed place
making sure that is protected from dust and dirt to assure its hygenic conditions. Moreover, it is
recommended to store the product in a place which can be reached easily by the personnel in case of
necessity.
Always remember that packing elements (paper, cellophane, stitches, adhesive tape, etc.)
can cut and/or hurt if they are not carefully handled.
They shall be removed with adequate means and shall not be left at the mercy of irresponsible
persons; the same is valid for tools used to remove packages (scissors, knives, etc.).
After opening the packages, first of all it is necessary to check all pieces and parts composing the
product. Check that they are all present and in perfect conditions.
During the assembly do not lean the bedsprings or the bedheads against the walls! They
may fall down or slip and cause damage to people and things.
Moreover pay attention to hinged elements, which can crushed your fingers.
Attention to burrs on pipes and couplings, if present remove them with suitable tools.
They can cause damage during the assembly or the use of the product.
Generally the two wheels without brake are installed in the bedhead, whereas the braking wheels are
installed in the bedfoot. In any case it is possible to position the wheels with or without brakes according
to the needs. During the assembly the brakes of the wheels must be blocked.
Once the installation has been concluded, check that the leg locking nuts are correctly tightened and
that the bedhead and the bedfoot are correctly inserted
FEATURES
PRESCRIPTIONS
UNPACKING
INSTALLATION
7