Turn It On & Off - Motorola RAZR V3t Manual De Usario

shows when the battery is charging. The
display shows Charge Complete when finished.
Tip: Relax, you can't overcharge your battery.
It will perform best after you fully charge and
discharge it a few times.
Note: You can charge your battery
by connecting a cable from your
phone's mini-USB port to a USB
port on a computer. Both your
phone and the computer must be turned on,
and your computer must have the correct
software drivers installed. Cables and
software drivers are available in
Motorola Original data kits, sold separately.
14 essentials
turn it on & off
Caution: On power up, the phone may
prompt you to enter your SIM card PIN code
to unlock the SIM card. If you enter an
incorrect PIN code three times before the
correct code, your SIM card is disabled, and
your display shows SIM Blocked. Contact
T-Mobile.
To turn on your phone,
press and hold the
power key O until the
keypad or display lights
up. If prompted, enter
your eight-digit SIM card
PIN code and/or four-digit unlock code.
To turn off your phone, press and hold O for
a few seconds.