Installation; Operation; Maintenance - Vortice THERMOLOGIKA DESIGN PLUS Manual De Instrucciones

ENGLISH

Installation

Fig. 3 ÷ 21.
NB
For the different connection modes see figure 17.
To connect the appliance in conformity with the
current regulations it is necessary to use one of the
following modes. (fig. 17). The pull cord switch
connects/disconnects the product from the power grid.
D1: wi-fi remote controller to predict at installation
(cod. 21380).
D2: plug activable through wi-fi (cod. 21379).
D3: plug activable through wi-fi with temperature
sensor (cod. 21378).
WARNING: It must be care of the installer selecting
the correct ratings of the Remote control switch or
Relay according to the number of the connected units.
NB
Thermologika Design must be installed horizontally
(fig.20).
WARNING: It must be care of the installer selecting
the correct ratings of the Remote control switch or
Relay according to the number of the connected
units.

Operation

Thermologika Design is switched on using the pull
cord on the right-hand side of the appliance; this
device can also be used to select the desired
operating power level:
"0" position: appliance OFF fig. 21 A
"1" position: 1500 W fig. 21 B
The status of the appliance is shown in the window to
the right of the logo.

Maintenance

Thermologika Design does not require any special
maintenance. Whenever necessary, wipe off any dust
from the outside with a soft dry cloth. Slightly damp
the cloth with water and neutral detergent to remove
stubborn dirt. Take special care under these
circumstances to avoid all contact with the quartz
lamps.
NB
Disconnect the appliance from the mains supply
before performing any maintenance.
7