Environmental Protection And Disposal; Declaration Of Conformity - Lister 1600-4 Instrucciones De Uso

Have the motor replaced
EN
Do not tighten pressure tensi-
on nut so much.
If the blades still do not cut,
they should be resharpened
or
replaced
Have it repaired by service
centre
Have it repaired by service
centre
Replace battery
6. Others
6.1.

Environmental Protection and Disposal

The owner has a duty to dispose of the clipper blades as well as of the clipping machine proper-
ly at the end of its service life. Please observe your relevant national regulations.
6.2.

Declaration of conformity

This device complies with the requirements of the following EU directives:
2004/108/EG
2006/95/EG
Runtime on a single charge
is too short and / or blades
are hot.
Oil Blades
Use intact, fully loaded origi-
nal batteries.
Green or red LED on the
charging station is not lit.
Connect charger to power
supply.
An inserted empty battery
the normal charging does
not start.
Clean contacts
Replace battery
Red LED flashes
Akku ist defekt
Page 20
Blades were not lubricated
enough
Empty, not fully charged, or
faulty batteries were used
Shearing tension too high
clipping
Charging station is not
connected to the power
supply.
Electronic unit defective
Contacts of the battery and /
or charger are dirty.
Battery is defective
Electronic unit defective
Battery defective
Akku ersetzen