Temperature Indicator; Power Indicator; Internal Unit Emergency Button; Auto Restart Function - Ferroli GOLD INVERTER Manual De Instrucciones

STARTING
INDICATORI LED UNITA' INTERNA
Fig.1
Di seguito viene descritto il significato dei LED situati nel pannello frontale del-
l'unità interna:
1. HEAT MODE INDICATOR
Lights up when the function is on.
2. COOL MODE INDICATOR
Lights up when the function is on.

3. TEMPERATURE INDICATOR

Indicates the set room temperature.
1 2 3 4 5

4. POWER INDICATOR

Lights up red when the unit is on standby, and green when the unit is working.
5. Dehumidification MODE INDICATOR
Lights up when the function is on.
Fig.2

INTERNAL UNIT EMERGENCY BUTTON

It allows turning the unit off and/or on in case of a remote-control unit fault.
Operating mode and the preset temperature are automatically adjusted depen-
1
ding on the room temperature at switch-on.
For these models, the ON/OFF Emergency button is on top right corner of indoor
unit (Fig.2-1).
1
AUTO-RESTART FUNCTION
The unit is programmed to switch on automatically in the event of a power failu-
re.
Fig.3

SWITCHING OFF AND SHUT DOWN

To switch off the conditioner, press the "ON/OFF" button on the remote control.
As soon as it is switched on, or when it is switched off and back on again, the
compressor does not start working immediately but waits three minutes in order
ON/OFF MO
to protect the system. Before switching off the unit for a long period, keep it run-
ning for two or three hours in the cooling mode with the temperature set to 30°C.
Then disconnect the power supply, clean the filters and remove the battery from
the remote control.
10