Indicator Lights - Tripp-Lite OMNISMART350HG Manual Del Propietário

Basic Operation

Indicator Lights

All Indicator Light descriptions apply when the UPS is plugged into an AC outlet and turned on.
"POWER" LED
For Smart Models Only: This green LED lights continuously when the UPS is ON
and supplying connected equipment with AC power from a utility source. The LED
flashes and an alarm sounds (4 short beeps followed by a pause) to indicate the
UPS is operating from its internal batteries during a blackout or severe brownout.
If the blackout or severe brownout is prolonged, you should save files and shut
down your equipment since internal battery power will eventually be depleted.
See "BATTERY CHARGE" LED description below.
For OmniSmart Models Only: This green light will turn ON whenever your UPS
is receiving normal AC line power. It will flash while the UPS is in CHARGE ONLY
mode to indicate that the UPS will not provide battery backup during a blackout
or brownout.
"VOLTAGE CORRECTION" LED (For Select Smart and OmniSmart Models):
This green LED lights continuously whenever the UPS is automatically correcting
high or low AC voltage on the utility line without the assistance of battery power.
The UPS will also emit a slight clicking noise. These are normal, automatic
operations of the UPS. No action is required on your part.
"OUTPUT LOAD LEVEL" LED (For Select Smart and OmniSmart Models):
For Smart Models Only: This multicolored LED indicates the approximate
electrical load of equipment connected to the UPS's AC outlets. It will turn from
green (light load) to yellow (medium load) to red (overload). If the LED is red
(either illuminated continuously or flashing), clear the overload immediately by
unplugging some of your equipment from the outlets until the LED changes from
red to yellow (or green) and the alarm is no longer sounding. CAUTION! Any
overload that is not corrected by the user immediately may cause the UPS
to shut down and cease supplying output power in the event of a blackout
or severe brownout.
For OmniSmart Models Only: This red light will turn ON continuously when the
UPS is providing power from battery or after the UPS runs a self-test to indicate
that the UPS's inverter is overloaded. If it lights up, immediately remove some
of the equipment connected to the UPS and run a self-test. CAUTION! Any
overload that is not corrected by the user immediately may cause the UPS
to shut down and cease supplying output power in the event of a blackout
or severe brownout.
15-12-160-9332C2.indb 10
continued
10
12/22/2015 9:25:14 AM