Storage Features
Freezer Features
Freezer Baskets
To Remove Upper Freezer Basket
1. Find the side where the basket frame is aligned to the clip
opening. The basket frame should be aligned to both front
and rear clips on the same side (either left or right side).
2. If the basket frame is not aligned to the left or right side,
push the basket sideways (to either side) until it is aligned.
3. By grabbing the basket wire frame close to the frontal clip,
pull up to take the basket frame out.
4. Grab the basket frame close to the rear clip and pull up until
it comes out of the clip.
5. Once one side of the basket is off the clips or retainers,
slide the basket sideways until the other side of the frame
is aligned with the clip openings on the opposite side of the
freezer.
6. In the same way, pull up the basket frame from the frontal
and rear clips until it is out of the clips.
7. Remove the basket.
Reverse the steps to reinstall the basket.
NOTE
If basket is not resting on stabilizer bar retainer
clips, the drawer will not close properly.
Removing Lower Freezer Basket Instructions
1. Locate the basket clips in the rear corners of the basket and
pull them out to remove.
2.. Open fresh food doors completely.
3. Lift the basket up and remove.
Clip
Stabilizer
Bar
Location of
basket clip.
One each side.
Replacing Lower Freezer Basket Instructions
1. Place freezer basket back inside the freezer drawer.
2. Replace clips by sliding them back into the slots.
Dividers Removal
Lift up on the front of the upper divider and pull out.
Upper Basket
Divider
Retainers
Stabilizer
Bar
Squeeze handle and lift up in the center of the divider to
move it side-to-side. (The divider cannot be removed.)
Tilt Wire Shelf
The freezer tilt wire shelf (located on the inside of the
freezer drawer) is not designed to be removed.
18
Pull to Remove
Push to Replace
Lower Basket
Divider