Changing The Water And Air Filters - AGA marvel AMLFDR23D Guía De Uso/Instalación

Changing The Water and Air Filters

Your refrigerator is equipped with separate water and
air filtering systems. The water filter system filters all
the water used to produce ice. The air filter removes
odors and impurities from the refrigerator compart-
ment.
About your advanced water filter
The ProChill filter system is
tested and certified by NSF
International to NSF/ANSI
Standards 42, 53 and 401 for the
reduction of claims specified on
the performance data sheet.
Do not use with water that is microbiologically unsafe
or of unknown quality without adequate disinfection
before or after the system. Systems certified for cyst
reduction may be used on disinfected waters that may
contain filterable cysts.
• Rated Capacity - 125 gallons/473 liters
• Rated service flow - .65 gallons per minute
• Maximum Rated Pressure - 100 pounds per square
inch
• Recommended Minimum Operating Pressure: 30
pounds per square inch
• Operating Temp.: Min. 33°F, Max. 100°F
NOTE
When ordering your replacement filter, please
reorder the same filter type that is currently in
your refrigerator.
Water filter
The water filter is located at the top right side of the
fresh food compartment.
Replacing your ProChill water filter
In general, you should change the water filter every
six months to ensure the highest possible water
quality. The Water Filter Status light on the Touch
Panel prompts you to replace the filter after a standard
amount of water (125 gallons/473 liters) has flowed
through the system.
If your refrigerator has not been used for a period of
time (during moving for example), change the filter
before reinstalling the refrigerator.
It is not necessary to turn the water supply off to
change the filter. Be ready to wipe up any small
amounts of water released during the filter replace-
ment.
To replace your water filter
1. Turn Off the ice maker power switch.
2. Remove the old filter by rotating it counter-clockwise (to the
left) 90 degrees to release it.
3. Slide the old filter cartridge straight out of the housing and
discard it.
Filter Cartridge
4. Unpackage the new filter cartridge. Slide it into the filter
housing as far as it will go with the grip end horizontal.
5. Push lightly inward on the filter while rotating it clockwise
(to the right). The filter will then pull itself inward as it is
rotated. Rotate the filter 90 degrees until it stops and the grip
end is vertical. You may be able to feel a very light click as
the filter locks into place.
6. Press a drinking glass against the water dispenser while
checking for any leaks at the filter housing. Any spurts
and sputters that occur as the system purges air out of the
dispenser system are normal.
7 Continue dispensing water for 3-4 minutes or until 1.5
gallons of water has flowed through the system. You will
likely need to empty and refill your glass several times.
8. Turn On the ice maker.
9. Press and hold the Water Filter reset button on the control
panel for three seconds. When the display changes from
Red to Green, the status has been reset.
21