Replacement Parts - GE GFWN1000 Manual Del Propietario E Instrucciones De Instalación

InStaLLIng tHE WaSHEr
7. Attach the U-shaped hose guide to the end of the
drain hose. Place the hose in a laundry tub or
standpipe and secure it with the cable tie provided in
the enclosure package.
nOtE: Placing the drain hose too far down the drain pipe
can cause a siphoning action. No more than 7 inches of
hose should be in the drain pipe. There must be an air
gap around the drain hose. A snug fit can also cause a
siphoning action.
Cable Tie
8. Plug the power cord into a grounded outlet.
nOtE: Check to be sure the power is off at the circuit
breaker/fuse box before plugging the power cord into
an outlet.
Installation Instructions
(cont.)
Cable Tie
Cable Tie
9. Turn on the power at the circuit breaker/fuse box.
10. Read the rest of this Owner's Manual. It contains
valuable and helpful information that will save you
time and money.
11. Before starting the washer, check to make sure:
o Main power is turned on.
o The washer is plugged in.
o The water faucets are turned on.
o The unit is level and all four leveling legs are firmly
on the floor.
o The shipping support hardware is removed
and saved.
o The drain hose is properly tied up.
o There are no leaks at the faucet, drain line
or washer.
12. Run the washer through a complete cycle.
Check for water leaks and proper operation.
13. If your washer does not operate, please review
the Before You call For Service section before
calling for service.
14. Place these instructions in a location near the washer
for future reference.

rEPLaCEMEnt PartS

If replacement parts are needed for your washer, they
can be ordered in the United States by visiting our
Website at GEAppliances.com or by calling
800.GE.CARES.
20